The CBE PC110 kit is an all-in-one, 12V installation kit built around the PC110 digital control panel and provides all the major components required to get your leisure electrical system up and running in your campervan or motorhome. The microprocessor-controlled PC110 control panel provides a host of functions for controlling and monitoring your electrical system and features capacitive touch switches and a multi colour LED display.
This kit is designed for use with lead-acid leisure batteries (not suitable for lithium) in vehicles with standard alternators (Euro 4 spec engines or earlier), although it can be modified to enable it to be used with 'smart' alternators (Euro 5 or 6 spec engines). Please see 'important note' below.
The CBE PC110 kit contains the following components:
- PC110 digital control panel with multi colour LED display
- DS300 12V fused distribution box
- DS120S 230V AC mini consumer unit with double pole 13A circuit breaker and RCD
- 230V AC junction box
- CB-516 16A 4-stage automatic battery charger
- Pair of screw probes for waste water tank level sensing
- Internal and external temperature sensors
- Wiring harnesses, connector blocks and terminals
Please note: A fresh water level sensor is not included with this kit but can be purchased separately here
The PC110 control panel provides the following functions:
- Voltmeter for checking starter and leisure battery health
- Indication of 240V mains connection
- Fresh water tank level indicator
- Waste water tank 'full' indicator
- Fresh water tank 'low' indicator
- Split charging indicator
- Starter battery over-discharge alarm
- Leisure battery over-discharge alarm
- 240V mains power ON indicator
- Awning light on/off switch
- Water pump on/off switch
- Main 12V power on/off switch
- Battery over-discharge protection
The DS300 12V fused distribution box provides the following functions
- Fused distribution for 10 circuits
- Split charging of leisure battery (lead-acid batteries only)
- Trickle charging of the starter battery (max. 2A) from mains charger
- Automatic control for 3-way fridge and electric step
- Connection point for solar panel controller (not included)
IMPORTANT NOTE:
This kit is intended for installation in vehicles that have a standard alternator (Euro 4 spec engine or earlier) so the voltage-sensing split charging feature will not work effectively in vehicles with a Euro 5 or 6 spec engine. If you wish to fit this kit in a vehicle with a Euro 5 or 6 spec engine then you will need to disable the split charging feature in the kit and fit a separate battery-to-battery (DC-DC) charger to charge your leisure battery from your alternator.
Please see Manuals & Guides tab for details.
PC110 control panel with digital display
- Voltage rating: 12V DC
- Panel colour: Black
- Screen specs: Multi colour LED
- Dims: 170 (W) x 80 (H) mm
- Fixing type: recessed panel mount
DS300 12V fused distribution box
- Voltage rating: 12V DC
- No. fuse locations: 11
- Fuse values: 3 - 30A (dependent on circuit)
- Battery low voltage cut-out: 10V DC
- Battery re-engage voltage (following cut-out): 12V DC
- Starter battery trickle charge bypass current: 2A max.
- Split charge relay rating: 70A
- Battery and ground stud size: M6
- Overall dims: 140 (W) x 180 (H) x 85 (D) mm
- Fixing type: Surface mount (mounting feet supplied)
DS120S 230V AC mini consumer unit
- Voltage rating: 230V AC, 50Hz
- Miniature circuit breaker rating: 1 x 13A double pole
- RCD rating: 25A, 30mA
- Overall dims: 140 (W) x 180 (H) x 85 (D) mm
- Fixing type: Surface mount (mounting feet supplied)
CB-516 16A switch mode battery charger
- Charging type: 4 stage automatic (bulk, absorption, float, stand-by)
- Input voltage rating: 230V AC nominal
- Output voltage rating: 13.5 - 14.3 V DC (depending on charge stage and battery type)
- Output current: 16A max.
- Battery compatibility: Wet & sealed lead-acid, gel, AGM (not compatible with lithium)
- Protection: Thermal overload
- Recommended battery capacity: 40 - 150Ah
- Overall dims: 140 (W) x 180 (H) x 85 (D) mm
- Max. working temp: 50°C
- Fixing type: Surface mount (mounting feet supplied)
The 12V distribution box, consumer unit and battery charger housings are modular and can be attached to each other horizontally or vertically to enable a compact installation.
Part Number : PC110KIT
.jpg)
.jpg)
.jpg)
.png)